Using Dynamic Web TWAIN in Microsoft Visual Basic 6

The following shows the steps of using Dynamic Web TWAIN in Microsoft Visual Basic 6.

1. Start Visual Basic 6.
2. In the New Project dialog box, click Open to new a Standard EXE project.
3. On the Project menu, click Component to display the Dynamic Web TWAIN dialog box.
4. Click the check box on the left of Dynamic Web TWAIN name to select Dynamic Web TWAIN, as seen in the following figure.
   
5. Click OK to close the Dynamic Web TWAIN dialog box. The Dynamic Web TWAIN will now appear in the Toolbox, as seen in the following figure.
   
6. From this point on, you can use Dynamic Web TWAIN in the same way as any other controls in Visual Basic.

TWAIN ActiveX | TWAIN Plug-in | TWAIN Control | TWAIN SDK | Scanner COM
Software Configuration Management | Version Control | Source Control
Copyright © 2011 Dynamsoft Corporation. All Rights Reserved.